Great Plains 9756PP Operator Manual - Manual (Page 25)

Great Plains Manufacturing, Inc. Operating Instructions 21
02/17/2014 580-043M
Rear Stand
Refer to Figure 13
If machine is equipped with a rear attachment, be sure you install
the rear jack stand so machine doesn’t tip backwards when unhook-
ing machine from tractor.
39. Attach the rear stand bracket to the center of, the rear
tube of the drag frame with 5/8 x 4 1/32 x 5 1/2 u-bolts ,
5/8 lock washers and 5/8 nuts.
40. Tighten u-bolts specs, See “Torque Values Chart” on
page 26.
41. Slide the rear stand through the rear stand bracket ,
secure with the 3/4 x 4 3/8 pin and retainer.
42. Once the options are installed, fold the plains plow to
check for clearance and interferences, also watch that
hoses do not get pinched.
Note: Double check that all bolts are tightened to specs, See
“Torque Values Chart” on page 26.Consult the “Oper-
ator’s Manual”, for the first time field adjustments before
going to the field.
4
Figure 13
Rear Stand
43039
3
1
2
1
2
3 1
4