Great Plains 8560 FCF Parts Manual - Manual (Page 33)

Revision Comments Part Description Part No. Ref.
Image No dwg41703
PIVOT SPINDLE 3 X 10 1/2 570-054D 1.
SEAL OIL CR27362 3.75X2.75X.44 816-220C 2.
BRG CONE 2.16ID JLM506849 822-110C 3.
BRG CUP 3.54OD JLM506810 822-109C 4.
WALKING BEAM RH 560-524H 5.
(shown) WALKING BEAM LH 560-525H 5.
GREASE ZERK STRAIGHT 1/4-28 800-001C 6.
BRG CUP 2.89ODX.58WD #LM501310 822-053C 7.
BRG CONE 1.62IDX.78WD#LM501349 822-048C 8.
1 HARDENED SPINDLE WASHER 148-404D 9.
NUT HEX SLOTTED 1-14 803-095C 10.
PIN COTTER 3/16 X 1 3/4 PLT 805-017C 11.
GREASE CAP 3.125 X .38 890-277C 12.
Includes items 1 thru 12 WALKING BEAM ASSEMBLY RH 560-526L 13.
WALKING BEAM ASSEMBLY LH 560-527L 13.
HHCS 5/16-18X4 1/2 GR8 PLT 802-803C 14.
NUT HEX TOP LOCK 5/16-18 PLT 803-166C 15.
Purchased Complete.See 8-Bolt Hub
& Spindle Assembly.
HUB 8-BOLT SPINDLE 2.75X17 608 815-251C 16.
HHCS 1/2-13X4 1/2 GR5 802-413C 17.
NUT HEX TOP LOCK 1/2-13 PLT 803-342C 18.
WHEEL 15X10 8 BOLT WHITE 814-223C 19.
TIRE 12.5LX15 LOAD F 814-227C 20.
Includes items 19 & 20 TIRE/WHL 12.5LX15 LOAD F WHITE 814-236C 21.
NUT LUG 5/8-18 X 90 DEG PLT 803-219C 22.
05/22/14 - 33 - 560-483P
Table of Contents Part Number Index
Section 3: Transport
8551-8560 Center Walking Beam Assembly
(Applies to 8551FCC, 8556FCC, 8560FCC only)