Great Plains 4000-3S Assembly Instructions - Manual (Page 4)

113-728M 2/28/2006
Great Plains Mfg., Inc.
Marker Option 4
Figure 6
Marker Rest Bracket to Second Marker Section
18926
Refer to Figure 6
2. Attach bumper (21) to marker rest bracket (22)
with a 1/2" x 3/4" bolt (23) and 1/2" lock washer
(24).
3. Attach marker rest bracket (22) to second mark-
er section (6) with 3/8" x 6" bolts (25) and 3/8"
lock nuts (26).
NOTE: The 34 inch dimension shown is from the cen-
ter of the hinge pin to the inner edge of rest bracket.
Refer to Figure 5
1. Assemble third marker section (14) to second
marker section (19) with 5/8" x 5" bolt (15) and 5/
8" nut lock (16). After hinge bolt is installed, take
as much play out of the assembly by tightening
both hinge bolt (15) and middle clamp bolt (17).
Stop tightening both bolts when all the play has
been removed. Do not over tighten. Check to
make sure arm (14) can be rotated by hand. Se-
cure opposite side with 7/16" x 2" bolt (17) and
7/16" nut hex lock (18).
NOTE: The 7/16" bolt (17) is the marker break away
bolt.
23204 Figure 5
Third Marker Section to Second Marker Section