Great Plains Hyd Hose Route - Manual

© Copyright 2004 Printed
Great Plains Mfg., Inc.
Used with:
Installation Instructions
196-416M
30’ No-Till Drill (Oct. 2004 and before)
Hyd. Hose Route Update
• 3N-3010P
• 3N-3020P
• 3N-3010
• 3N-3020
General Information
When you see this symbol, the subsequent instructions and
warnings are serious - follow without exception. Your life and
the lives of others depend on it!
!!
These instructions explain how to install the wing hy-
draulic hose route update kit. Hose routing hardware
for hoses going to the left-hand and right-hand wings.
Fits any 30’ production drill built prior to Nov. 2004.
These instructions apply to:
196-415A 30P Wing Hyd. Hose Route Update.
Manual Update
Refer to the 30’ No-Till Drill operator’s manual for de-
tailed information on safely operating, adjusting,
troubleshooting and maintaining the 30’ No-Till Drill.
Refer to the parts manual for part identification.
196-2448M Operator’s Manual
196-248P Parts Manual
196-366M Operator’s Manual
196-366P Parts Manual
11/09/2004
Before You Start
Page 3 is a detailed listing of parts included in the 30P
Hyd. Hose Route Update Kit package. Use this list to
inventory parts received.
Tools Required
• Basic hand tools
Definitions
Right-hand and left-hand as used in this manual are
determined by facing the direction the machine will
travel while in use unless otherwise stated.
Assembly Instructions
Refer to Figure 1
1. With the drill unfolded and working on the left-
hand side of the drill, place the center left-hand
hose guide on top of the center frame.
2. Hold in place with a 3/8" x 1 1/2" bolt (not visible
under hoses in picture). Insert bolt through the
cylinder lock storage hole. Add a 3/8" lock washer
and 3/8" nut and tighten.
3. Route hoses through the wire ring and place on
top of the hose guide. Hold hoses in place with
the hydraulic hose clip, 3/8" x 1" bolts, 3/8" lock
washers and 3/8" flat washers.
Figure 1 22776
Hose Guide
Hose Clip