Great Plains NTA2000 Operator Manual - Manual (Page 12)

10 NTA 2000 148-561M 2/2/2006
Great Plains Mfg., Inc.
Figure 1
Hitch
Figure 2
Jack in Transport
Hitching Tractor to Implement
!
DANGER!
You may be severely injured or killed by being crushed be-
tween the tractor and drill. Do not stand or place any part
of your body between drill and moving tractor. Stop tractor
engine and set park brake before installing pins.
Refer to Figure 1
1. Place hitch weldment (1) over ball swivel on hitch
tongue (2). Hold hitch weldment in place by insert-
ing spacer tube (3) through hitch clevis and ball
swivel.
2. Back tractor up to hitch and bolt hitch weldment to
tractor drawbar using 1” x 10" bolt (4), large flat
washer (5), lock washer (6), and nut (7).
3. Use 3/4” x 9" bolt (8) to bolt hitch weldment through
its slotted hole and onto secondary hole of tractor
drawbar. Install a 3/4” flat washer (9) next to top
slotted hole and fasten with a lock washer (10) and
nut (11). Tighten both bolts.
4. Securely attach safety chain to tractor-drawbar
frame.
5. Plug light harness and monitor leads into tractor
connections.
6. Connect hydraulic hoses to the tractor remotes.
7. Connect drill hydraulic brake hose to tractor brake
remote.
Refer to Figure 2
8. Remove jack from stob on side of hitch tongue and
place in transport position on implement.
17215
19730