Preparation and setup, Prior to going to the field checklist – Great Plains 4000TC Operator Manual User Manual
Page 17
08/01/2012
586-239M
Great Plains Manufacturing, Inc.
13
Preparation and Setup
This section helps you prepare your tractor and 1200-
4000TC Turbo-Chopper for use, and covers tasks that
need to be done seasonally, or when the tractor/Turbo-
Chopper configuration changes.
Before using the Turbo-Chopper in the field, you must
hitch it to a suitable tractor, inspect systems and level the
Turbo-Chopper. Before using the Turbo-Chopper for the
first time, and periodically thereafter, certain adjustments
and calibrations are required.
Prior to Going to the Field Checklist
Complete this checklist before routine setup:
❑ Read and understand “Important Safety Informa-
❑ Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
❑ Make sure your tractor horsepower matches the
implement you are pulling. This is important so the
implement can do the best possible job.
❑ Clean all hydraulic couplings and connect to tractor
as shown on page 14-16.
❑ If machine is folded, remove the transport pins from
wing stops. (DO NOT remove pins if the wing is lean-
ing against the pins or putting pressure on the pins.
Use the hydraulics to pull the wings in completely
before unpinning them.) Once the pins are removed,
slowly untold the unit. Make sure no one is under the
wings during the unfolding process.
❑ Check again for hydraulic leaks and watch that
hoses do not get pinched in hinges, wing stops, etc.
❑ After the machine is completely unfolded, raise and
lower the Turbo-Chopper several times to purge air
from the hydraulic system. Again check for hydraulic
leaks and tighten or replace if necessary.
❑ Check safety chain hookup. Make sure all warning
lights are hooked up and functioning correctly.
❑ Check that all grease fittings are in place and lubri-
cated. See “Lubrication” on page 26. The hubs will
come pre-greased and will not need greased at this
time.
❑ Check that all safety decals and reflectors are cor-
rectly located and legible. Replace if damaged. See
“Safety Decals” on page 5.
❑ Inflate tires to pressure recommended and tighten
wheel bolts as specified. See “Tire Inflation & War-
ranty” on page 30.
❑ Put transport locks in place and refold the machine
slowly. Put wing stop pins in place. Always use the
transport pins when moving from field to field. You
are now ready to go to the field.