Great Plains 1205NT Assembly Instructions - Manual (Page 2)

2 Agitator Front Parts Great Plains Mfg., Inc.
118-598M Front Parts 2014-06-16
Notations and Conventions
The following terms are used throughout this manual.
Note: Paragraphs in this format provide useful
information related to the current topic.
“Left” and “Right” are facing in the
direction of machine travel. An
orientation rose in the line art
illustrations shows the directions of
Left, Right, Front, Back, Up, Down.
Call-Outs
Before You Start
Inventory
Make sure all parts are present.
Comprehension
Review these instructions. Make sure the installers
understand where each part or assembly is installed,
and what tools are required for the task.
Pre-Assembly Preparation
Work Location
1. Move the drill to a location with:
2. Clean out the main seed boxes. See Operator
Manual for instructions.
If treated seed has been used, open seed cup doors
to clean-out position, wash out the boxes,
thoroughly rinse the boxes, and allow them to dry.
Do this in a suitable location other than where the
installation work is to be performed.
3. Lower drill.
4. Set all hydraulic remote circuits to Float (to ensure
that pressure is relieved). Shut off tractor or
hydraulic source.
5. Put the tractor in Park. Remove the key.
U
D
F
B
L
R
to
Single-digit callouts identify components in
the currently referenced Figure or Figures.
to
Two-digit callouts in the range 11 to 78
reference new parts (see list on page 12).
1 9
11 78
• adequate illumination; and,
• clear surface beneath for recovery of any fallen or
dropped parts - if the surface is not clear, have a
tarp or drop cloth available.