Toolbar height – Great Plains 2S-2600HDF Predelivery Manual User Manual
Page 27
Great Plains Manufacturing, Inc.
Setup
25
08/01/2007
195-069Q
Toolbar Height
Toolbar height
above ground level
is factory set and
normally does not require adjustment. If you tear down
the drill for repair, or if the tool bar is visibly not level,
spacer washers
on vertical pivot pins allow for a small
amount of tool bar-height adjustment.
To check tool bar height, park drill on a level surface, and
check for correct tire inflation. Measure from ground to
horizontal pivot pin
. If dimension on either side of drill
varies more than
1
⁄
4
inch (6.4mm), adjust tool bar height.
To adjust tool bar height, reposition spacer washers
.
First lower openers and set enough opener down pres-
sure to help balance frame. Raise tool bar by removing
spacer washers from top of the vertical pivot and placing
them on bottom side of pivot. Lower tool bar by removing
spacer washers from bottom of vertical pivot and placing
them on top of pivot.
Figure 28
Toolbar Height
17306
3
1
2