Great Plains 2S-2600HDF Predelivery Manual - Manual (Page 11)

Great Plains Manufacturing, Inc. Assembly 9
08/01/2007 195-069Q
Locate Ladder Mount Holes
Refer to Figure 4 or Figure 5
Where to place the top ladder mount depends on whether
the drill has the Small Seeds option. Install with reference
to the appropriate Figure for the drill.
Refer to Figure 5
Top mount weldments are provided in left-side and
right-side versions and are not interchangeable. All other
parts may be used on either end. Start with the left wing:
1. Select one:
195-063H LADDER MOUNT TOP WELDMENT LH ,
and four:
802-030C RHSNB 7/16-14X1 3/4 GR5.
2. Position top mount over the four walkboard holes
appropriate for the configuration (see above).
3. Insert the four bolts to loosely hold the top mount
in place on the walkboard .
4. Select one:
195-340D LADDER MOUNT BOTTOM PLATE
and four sets of:
804-014C WASHER LOCK 7/16 PLT
803-015C NUT HEX 7/16-14 PLT
5. Position the bottom plate under the walkboard
and inside the top mount . Loosely hold it in place
with the washers and nuts .
6. Select two sets of:
802-017C HHCS 3/8-16X1 GR5
804-013C WASHER LOCK SPRING 3/8 PLT
803-068C NUT HEX FLANGE 3/8-16 PLT
7. Insert the screws through the side holes in both
the top mount and bottom plate , and secure
with lock washers and flange nuts .
8. Tighten the four 7 ⁄
16
in nuts on bolts , securing
the top mount to the bottom plate .
9. Selecting one:
195-064H LADDER MOUNT TOP WELDMENT RH
in place of mount , repeat step 1 through step 8 for
right wing section.
Figure 4
Small Seeds Mounting
27055
13
17
16
22
20
15
23
19
4
13
13
17
13
4
17
4
15
23
19
Figure 5
Mount w/o Small Seeds
27036
13
17
16
22
20
15
23
19
4
15 4
13
23 19
16
22
20
16
13 15
22 20
19 17
13
15
14
13