Great Plains 2S-2600HDF Predelivery Manual - Manual (Page 13)

Great Plains Manufacturing, Inc. Assembly 11
08/01/2007 195-069Q
Install Fixed Walkboard Steps
Refer to Figure 7
1. Use the 1 ⁄
2
x1 3 ⁄
4
inch bolts , lock washers and hex
nuts to bolt a walkboard and step on outside
ends of a wing.
Note: The steps are not interchangeable. Bolt steps so
that steps jog away from the end panel and extend
back.
2. Repeat for other wing.
Apply Reflectors and Decals
To prevent scuffing in shipment, walkboard decals are
shipped in a bag in one of the drill boxes, and are applied
after walkboard installation.
The precise location of the outside wing decals depends
on whether a fixed step or swing-down ladder is installed.
To install new reflectors and decals:
• Clean and dry the area where the reflector or decal is
to be placed.
• Peel backing from reflector or decal. Press firmly on
surface, being careful not to cause air bubbles under
reflector or decal.
Wing Walkboard Inner Decals
Refer to Figure 8
Starting with the left walkboard, inboard end:
1. Place one 838-266C Red decal on the outside
end. Align the outside end of the decal with the walk-
board corner. This decal marks the left and right
extents of the drill in transport (folded).
2. Place one 838-265C Amber decal on the rear face
of the walkboard. Align the rear end of the decal with
the inboard walkboard corner.
3. If 838-267C Daytime reflector decals are sepa-
rately provided, place one on the frame channel
inboard of the red reflector.
4. Repeat for right wing walkboard.
Figure 7
Walkboard Step & Outer End
18810
1
2 4
5
6
5
4 1 6
6
Figure 8
Wing Walkboard Inner End
27052
1 2
3
1
2
3