Great Plains Yield-Pro Planters Refuge Hopper Kit - Manual (Page 4)

4 Great Plains Manufacturing, Inc. Front Page Part Lists YP Refuge Hopper Kit
403-287M Front Page Part Lists 05/11/2011
Adjust Walkboard
Remove Walkboard Extension
Note: This applies to all planters except the YP2425
and YP2425A which have dual hoppers and the
walkboard is not located at the rear.
Refer to Figure 4
13. Walkboard should still be swung out to side.
14. It is necessary to make room to fit the refuge hop-
per on the planter.
Using a torch cut off the smaller walkboard exten-
sion piece. (You will be cutting through the bracket
that is welded to the bottom of both walkboard sec-
tions).
15. It is recommended to use a grinder to smooth the
edges. Spray with aerosol spray paint to prevent
rusting.
Null4:
Move Walkboard Back 4 3
⁄
4
inches
Refer to Figure 5
16. To allow room for the refuge hopper, move the walk-
board mount back 4
3 ⁄
4
inches to back set of
prepunched holes on the frame. Attach with existing
hardware.
Figure 4
Walkboard Extension
13128
Figure 5
Walkboard Set Back
31331