Warning – Great Plains 8030-3P Wide Row Planters User Manual
Page 9
-
7
4/9/04
Great Plains Mfg., Inc.
Section 2 Assembly Instructions & Set-Up
3-Point Wide Row Planter Flat Fold Marker 113-519M
4.
Install the cylinders into the marker mounts (#1 & 2),
Figure
2-2, retain cylinders with the pins and spac-
ers. Slide the mounts and excess hoses into the
frame. Install bolts and tighten (Torque value charts
page 4).
5.
Connect hoses to tractor and cycle cylinders in and
out several times and purge any air that may be in
cylinders. (Note the cylinders will alternate extend-
ing.) Retract both cylinders shut off tractor and in-
spect for any hydraulic leaks as described in Section
1 of this manual
!
WARNING!
If a hydraulic leak develops, correct it immediately. Escaping
hydraulic oil can have extremely high pressure. A stream of
high pressure oil may easily penetrate the skin as with modern
needle-less vaccination equipment - but with the exception
that hydraulic fluid may cause blood poisoning. It is impera-
tive that the connections are tight and that all lines and pipes
are in good condition. .
2-3 for the remainder of the Instructions.
6.
Install the 1st stage arms(#1). Leave arms resting
on the down stops.
7.
Install pivot links (#2). Refer to Illustration for proper
orientation.
8.
Install the 2nd stage mount, 2nd stage, and the ex-
tension tube (#3, 4, & 5) onto the end of the 1st
stage arms.
9.
Install transfer links (#6) to pivot links and 2nd stage
mounts.
10. Start tractor and slowly extend one of the cylinders
out approximately 6 inches. Shut tractor off and by
raising the end of the 2nd stage attach the cylinder
and the pivot link. Check all hardware on the marker
to specifications then start tractor and fold marker to
the storage position.
11. Extend opposite cylinder approximately 6 inches.
Shut tractor off and repeat step 10.
12485
Cylinder to Mount Installation
Figure
2-2
13333
Mount, First, & Second Stage Assembly
Figure
2-3