Great Plains 1006NT Operator Manual - Manual (Page 9)

-
7 9/13/04 Great Plains Mfg., Inc.
Section 2 Assembly Instructions & Set-Up
706/1006 Seed Box Agitator 118-903M
Agitator Shaft Installation
Referring to Figure 2-2, remove the bearing cutout cov-
ers (#1) saving the 5/16"-18 round head square neck
bolts, 5/16" lock washers and 5/16" nuts for reuse in the
same location.
If you have a small seeds drill without fertilizer, you will
need to remove the current bolt and hardware from the
rear hole and install the agitator idler bolt (#2), jam nut,
flat washer, and 17 tooth sprocket (#3) into the rear hole
of the false end panel on the left hand side fo the seed
box.
Box Disassembly
Figure 2-2
21831