Great Plains 8560 FCF Predelivery Manual - Manual (Page 13)

Great Plains Manufacturing, Inc. Assembly 9
02/10/2014 560-484Q
Install Caster Style Gauge Wheel
Refer to Figure 7
Note: Some models will be shipped without the gauge
wheels installed. Be sure and install the 1 x 5 1/2 pin
as shown with roll pin in slot on outside of pivot
mount . See “Tires Chart” on page 12, for proper
tire sizes for tire/wheel assembly
48. Start by installing the LH or RH caster wheel arm
and top caster wheel arm to the brackets on
frames with 1 x 5 1/2 gauge wheel pin , 7/8 flat
washers and 7/8 lock nuts.
49. Fasten back side of turnbuckle assembly to LH or
RH wing pull bar (level bar on center section), front
side to lever to caster wheel arm with 1 x 3 11/16 cle-
vis pins
and 3/16 x 2 cotter pins.
50. Attach the pivot mount assembly to caster wheel
arms and , secure with 1 x 5 1/2 gauge wheel
pins , 3/8 x 2 roll pins, 7/8 flat washers and 7/8
lock nuts.
51. Slide 6-bolt hub assembly into pivot mount assem-
bly , align holes, secure with 5/16 x 3 hex bolt
and 5/16 lock nut.
52. Attach the wheel/tire assembly to 6-bolt hub
assembly and secure with 9/16 lug nuts .
53. Tighten bolts to specs, See “Torque Values Chart”
on page 11.
Note: See “Operator’s Manual” for proper adjustment of
gauge wheel assembly.
Figure 7
Gauge Wheel (Caster Style)
41892
U
D
F
B
L
R
6
1
8
7
3
5
10
11
3
4
2
4
9
3
6
10
1
2
3
4
5
6
7
1 2
3 4
8
7 9
10
11