Great Plains Planter Hopper Lid Latch Kit - Manual (Page 2)

2 Great Plains Manufacturing, Inc. Front Page Part Lists PLANTER HOPPER LID LATCH KIT
403-621M Front Page Part Lists 2012-04-03
Remove Old Latch Tab
Refer to Figure 2
1.
Remove a lid . Locate the latch end, which has a
single molded center tab . The hinge end has two
molded tabs.
Equipment Damage Risk:
Do not remove the hinge tabs, or the lid will become useless.
2. Using a cut-off wheel or die grinder, remove the
molded latch tab
, leaving a flush smooth surface
on the inside of the lid rim.
Drill Mounting Hole
Refer to Figure 3
3.
At the lid end where the latch tab was removed, mark
a hole location on lid center-line, and 16.8 mm from
the bottom edge of the lid rim.
4. Drill a 7.1 mm (
9 ⁄
32
inch, letter size K) hole at this
location.
Figure 2
Remove Latch Tab
34142
1
21
21
1
1
Figure 3
Latch Hole Location
34143
21
16.8 mm
.661 in
21 ⁄
32
in.