Great Plains Flex Harrow Light Kit - Manual (Page 2)

2 Light Kit Great Plains Manufacturing, Inc.
564-092M 12/15/2011
Side Hole Placement
Refer to Figure 2
2.
Drill two 9/16 holes in location shown on both sides.
Light Bracket Mounting
Refer to Figure 3
3.
Fasten light bracket assembly to the pre-drilled
holes with the 1/4 x 3/4 self tapping screws .
4. Fasted light bracket assembly in position shown
with the 1/2 x 1 1/2 hex bolts , 1/2 lock washers
and 1/2 nuts.
5. Tighten all bolts.
6. Route wiring harness from front of hitch along
hydraulic hoses and across to light brackets. Route
wires through bent tubing on outer light brackets and
plug ends into lights as marked on harness.
7. Fasten wiring harness with plastic ties or hose clips.
Be sure wire is fastened securely so it doesn’t drag
or get pinched when folding machine.
8. Clean surface and attach red and orange
decals on bottom of tube in line with light bracket
assembly
as shown on both sides.
9. Clean surface and attach amber decal in position
shown on both sides of center frame bracket.
Refer to Figure 4
10. Clean surface and attach amber decal
in position
shown on both sides of hitch angle tube.
FigureSpacer:
Figure 2
Side Hole Placement
42306
FigureSpacer:
Figure 3
Light Bracket Mounting
42307
3 4
1
2
6
7
5
1
2
3
4
5 6
1
FigureSpacer:
Figure 4
Amber Decals Hitch Location
42406
7
7
7
7