ClearOne MAX IP Response Point Quick Start - Manual (Page 4)

Page 4
lcD DisPlay
using the Phone
make a call
Press the 1. key to activate the
phone. You will hear a chime or spoken
prompt.
Speaking clearly, say the name of the 2.
person in your Contact List you wish to call.
oR
Press the 1. key to activate the
phone. You will hear a dial tone.
Dial the number as you would on a 2.
standard phone. The number appears on the
LCD screen.
You can also pre-dial the number while in
Standby mode and press the
key
to connect the call.
To add a pause to the number you are
pre-dialing, press and hold the pound
(#) key.
answer a call
• When there is an incoming call, the
following will occur:
the phone will ring (unless the ringer is 1.
turned off).
the phone's 3 LeDs will flash. 2.
the phone icon on the LCD screen will 3.
flash.
To answer • press the key.
end a call
• Press the key.
turn the Ringer on/off
• Press and hold the "*" key until the Ringer
Off icon appears on the LCD display.
adjust Ringer Volume
• While the phone is ringing, press
or .
• While the phone is inactive, press
or . The ringer melody will
play once at the new level.
Dial an internal call
to dial an internal company extension using
voice dialing:
Press the 1. button on the phone.
Say the name of a person in your 2.
directory (e.g. “Denise Smith”). You can also
speak the name of a specific location or
department, such as “kitchen” or “accounts
payable,” as long as those extensions are
listed in the directory.
to dial a call manually (using the keypad:)
Dial the extension number (optionally, 1.
followed by “#”) of the co-worker or
department you wish to contact.