Installation instructions, Step 2, Step 3 – Quoizel MNR1615BN Manor User Manual
Page 2: Step 1
INSTALLATION INSTRUCTIONS
2 OF 4
STYLE NUMBER: MNR1615XX
Nipple
Hex Nut
Ceiling Canopy
STEP 2
:
a.
Thread another Hex Nut onto the other end of the
nipple. Thread this Hex Nut on just enough so the
inside surface of the pan rests against it.
You may have to trial fit the Ceiling Canopy one more
times to insure this distance also. This Hex Nut is
needed here to prevent you from crushing down the
center of the Ceiling Canopy
*
.
WHITE OR RIBBED
BLACK OR RED WIRE
(
)
FROM HOUSE
GROUND WIRE
GROUND WIRE
FROM HOUSE
FROM FIXTURE
WHITE OR RIBBED
FROM FIXTURE
FROM HOUSE
FROM FIXTURE
BLACK OR SMOOTH
STEP 3
:
*
(
)
.
.
.
(
)
(
)
.
(
)
(
).
.
.
Use Wire Connectors not supplied to connect the
wires
a
Connect the House Ground Wire to the Fixture Ground
Wire.
b
Connect the House White
or Ribbed
Wire to the
Fixture Supply Wire White or Ribbed Side .
c Connect the House Black or Red
Wire to the Fixture
Supply Wire Black or Smooth Side
d Wrap each connection with approved electrical tape and
carefully stuff all of the connected wires into the Outlet
Box
Outlet Box
Outlet Box
Screw
Hex Nut
Crossbar
Lock Washer
Nipple
Ceiling Canopy
STEP 1:
a
Locate the Crossbar and attach it to the Outlet Box
using the Outlet Box Screws
not supplied
b
Locate the Nipple and thread one Hex Nut onto it
about half way. Slip a Lock Washer onto it and thread
one end of the nipple into the center hole of the
Crossbar
c
Position the Ceiling Canopy over the outlet box,
passing the mounting hole in the center of the Ceiling
Canopy over the end of Nipple
d
Adjust the Nipple so approx
3 8
inch of the Nipple is
protruding from the mounting hole. This adjustment
may take a few tries.
e When this length is achieved, remove the Ceiling
Canopy and tighten the Hex Nut up against the
underside of the Crossbar with pliers.
.
.
.
.
.
(
).
.
.
. / "