beautypg.com

Figure 1, Installation instructions – Quoizel YU5149IB Yuma User Manual

Page 2

background image

FIXTURE SUPPLY
WIRE

LOCK WASHER A

LOCK NUT A

NIPPLE

LOCK NUT B

LOCK WASHER B

CANOPY CHAIN LOOP

COUPLING

FIXTURE CHAIN

CEILING
CANOPY

CANOPY LOCK
RING

FIGURE 1.

HOUSE SUPPLY
and GROUND
WIRES

HOLE DRILLED
INSIDE OUTLET
BOX

OUTLET BOX

SET SCREWS

INSTALLATION INSTRUCTIONS:
(

FOR FIXTURES OVER 25 LBS. (Canada Only)

Quoizel recommends a licensed electrician or contractor be
consulted for this installation.

3/8-18 NIPPLE, LOCK
WASHER AND
HEX NUT (INCLUDED)

COTTER
PIN

Please use the information outlined in this sheet for the ceiling
installation part of your fixture assembly.

1. Before installing fixture, carefully unpack and identify all parts

referring to illustration FIGURE 1. Be sure the power to the

installation point is OFF

.

2.

3. With the NIPPLE properly situated, locate COUPLING and proceed

to thread onto the end of the NIPPLE protruding into the OUTLET
BOX. Thread COUPLING onto pipe until tight. Tighten the top SET
SCREW with pliers to secure COUPLING to NIPPLE.

4.

Proceed to unravel the FIXTURE

SUPPLY and GROUND WIRES. Attach one end of the FIXTURE
LOOP at the top of FIXTURE. Please note that depending on chain
material thickness, you might be required to use chain pliers to
spread chain links open. Proceed to pass the FIXTURE SUPPLY
and GROUND WIRES through the chain, alternating links. Proceed
the pass the wires through the following mounting components in
this order: 1) CANOPY LOCK RING

2) CEILING CANOPY

Position the fixture under the OUTLET BOX. Locate the

fixture wires through the bottom center of

the COUPLING. Pull wires through the wire way hole on side of
COUPLING.

Proceed to thread the NIPPLE into the bottom center of the

COUPLING until tight. Tighten the LOWER SET SCREW. Proceed
to thread LOCK NUT A and LOCK WASHER A up NIPPLE until

seated against the bottom of the COUPLING. Tighten until snug
with pliers. Attach the top of the FIXTURE CHAIN to the CANOPY

CHAIN LOOP.
Using wire connectors (not supplied),

connect the HOUSE

WHITE WIRE to the FIXTURE SUPPLY WIRE (WHITE or RIBBED
SIDE); connect the HOUSE BLACK (or RED)WIRE to the FIXTURE
SUPPLY WIRE (BLACK or SMOOTH SIDE). Wrap
connection with approved electrical tape.

5. With the proper connections made roceed to push the CEILING

CANOPY upward over the OUTLET BOX. Be sure that all wires are
carefully tucked into the OUTLET BOX cavity. Secure canopy
against ceiling by threading CANOPY LOCK RING onto the
CANOPY

LOOP. Tighten until snug.

(Quoizel recommends (2) people for

the rest of this installation)

.

Making the connections:

;

;

at circuit breaker

e

e

CANOPY

CHAIN LOOP; LOCK WASHER B and LOCKNUT B;
NIPPLE ; LOCK NUT A and LOCK WASHER A. Thread
LOCK NUT A onto top end of NIPPLE. Pass LOCK WASHER A over
top end of NIPPLE. Thread LOCK NUT B onto the end of NIPPLE.
Pass LOCK WASHER B over end of NIPPLE. Thread the CANOPY
CHAIN LOOP onto the end of NIPPLE. Thread LOCK NUT B down
NIPPLE and snug against top of CANOPY CHAIN LOOP with pliers.

Pass wires through the bottom center CANOPY CHAIN LOOP

through NIPPLE. Pass

Take up wire slack and trim wires so that approx. 6” will

remain inside outlet box.

connect the FIXTURE

GROUND WIRE to HOUSE GROUND WIRE

each

p

CHAIN

6. Refer back to Page 1, Step 9 and finish installation.

(Refer to Figure 2, page 3) This weight of this fixture will require

a means of support independent of the OUTLET BOX. This
fixture must b supported by 3/8-18 NPSM NIPPLE(supplied)
Th NIPPLE should be positioned so that 3/4“ protrudes into
the OUTLET BOX cavity. Note: the opposite end of the NIPPLE
must be attached to a structural or bridging member of
sufficient strength to support the fixture weight. A COTTER PIN
has been included and should be installed into the top of
NIPPLE, above HEX NUT for added safety. A clearance hole
must be drilled on the inside top center of the OUTLET BOX.
Please refer to Figure 2, page 3 for detailed illustration. We

recommend the consultation of a licensed electrician or

contractor due to the complexity of this installation.

6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com

,

.

.

.

IS YU5149
Page 2 of 3

Revised 2008 01 28

-

- -