Quoizel UPCC2825IS Uptown Columbus Circle - Manual (Page 7)

Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
7of8
STEP 9 - Make Wire Connections
A. Un-thread the Canopy Lock Ring (G) and slide Canopy Lock
Ring (G) and Ceiling Canopy (E) down the Fixture Chain.
B. Push all slack fixture wire through Canopy Chain Loop into
Outlet Box. Trim excess fixture wire leaving a minimum of 6
inch. Hanging out of the Outlet Box.
C. Use standard wire connectors to make all wire connections.
(Connectors are not included with fixture.) Strip and prepare
wire ends according to instructions supplied with connectors.
D. Connect White Supply Wire from the Outlet Box to White
Wire from fixture.
E. Connect Black (or Red) Supply Wire from the Outlet Box to
Black Wire from fixture.
F. Connect Ground Wire from the Outlet Box to Ground Wire
from fixture.
G. Twist connectors until wires are tightly joined together.
H. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
G. Re-attach the Ceiling Canopy (E) as shown in Step 6.
Figure 10
White wire from supply White wire from fixture
Black wire from supply
(or Red)
Black wire from fixture
Ground wire from supply Ground wire from fixture
Figure 9
Canopy Chain
Loop
Fixture Chain
Supply Wire and
Ground Wire
Supply Wire
and Ground
Wire from
Outlet Box
Ceiling
Canopy
Canopy Lock Ring
Assembly Instruction Sheet #IS-UPCC2825IS
For Style UPCC2825IS
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
2012 QuoizelInc. October2012
STEP 10 Assemble Shade -
A. Place the Shade (O) inside of the Socket Assembly (L). Pass
Sockets and Stem through the center hole on the bottom of
the Shade (O). Seat the Shade (O) onto the Shade Holder.
B. Pass Sockets through the Bracket (N) and place the Bracket
(N) over the Stem. Secure by threading the Knob (M) onto the
Stem. Hand tighten until snug.
Knob
Bracket
Shade
Socket
Stem
Figure 11
Socket Assembly
Shade Holder