Quoizel PCCS2824C Platinum Collection Cascade User Manual
Package contents, Warnings and cautions, Hardware contents

Package Contents
Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC 29445
Customer Service
Phone 631.273.2700
Fax
631.231.7102
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape,
safety glasses.
Bulb Recommended: (5) Medium Base 60W Maximum, Alternate bulb (5) 13W CFL
Estimated Assembly Time:
Preparation:
30-45 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams
below to be sure all parts are present. If any parts are missing or damaged, do not attempt to assemble, install, or
operate the fixture. Contact customer service for replacement parts.
Warnings and Cautions
1of3
Assembly Instruction Sheet #IS-PCCS2824
For Styles PCCS2824C, PCCS2824C1
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at
2014 QuoizelInc.
April2014
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Hardware Contents
Figure 1
AA
BB
CC
Crossbar Assembly
x 1
Lock Ball
x 2
Lock Screw
x 3
STEP 1 - Install Shade
A. Attach the Shade (N) to the Socket
Assembly (L) and secure with the Lock
Screws (CC). Hand tighten until snug.
Figure 2
A
B
C
E
F
G
H
I
L
F
G
H
H
K
J
L
N
K
String A
x 1
String B
x 3
String C
x 6
String D
x 5
Rod 12
”
x 1
Rod 6
”
x 2
Rod With
Nipple
x 1
Ceiling
Canopy
x 1
Quick Link
x 1
Socket
Assembly
x 1
Shade
x 1
Loop Ass embly
x 1
GN D
2. 4m m
13 Ga
QU OIZ E L
R
M
Diffuser
x 1
CC
L
N
D
String D
x 9
STEP 2
Assemble the Rods and the Loop
-
Assembly
A. Determine the Rods (F/G/H) to be assembled to
the Socket Assembly (L) according to your
hanging height.
B. Pass the supply wires and ground wire through
the chosen rods (F/G/H) and the Socket
(K). Thread the Socket Assembly (K), the
chosen Rods (E/F/G) and the Loop
Assembly (J) together as shown.
Hand tighten until snug.
Suggested rods for Ceiling height :
8
’ ceiling : use (1) 6” rod and (1) 12”
rods
9
’ ceiling : use (1) 6” rod and (2) 12”
rods
Supply Wires and
Ground Wire
STEP 3 - Attach Quick Link
A. Pass the Supply Wires and Ground
Wire through the Quick Link (J) and the
Ceiling Canopy (I). Connect the Loop
Assembly (L) to the Ceiling Canopy (I)
with the Quick Link (J).
Supply Wires
and Ground
Wire
Figure 3
J
I
K