Quoizel TF879CVB Larissa - Manual (Page 2)

INSTALLATION INSTRUCTIONS
Outlet Box
Crossbar
Outlet Box
Screw
STEP 1 :
a. Secure the Crossbar onto the Outlet Box with Outlet Box
Screws. Tighten until snug.
STEP 2:
* Pliers is required on this step.
a. Thread one Hex Nut onto top end of the Nipple.
b. Place one Lock Washer over the top end of the Nipple
and then thread the Nipple into the center lock hole of
the Crossbar.
c. Using pliers, thread the Hex Nut against the crossbar
and hand tighten until snug.
d. Thread another Hex Nut onto the bottom end of the
Nipple.
Lock Washer
Crossbar
Hex Nut
Nipple
Hex Nut
STEP 3 :
a. Adjust the Fixture Chain to your desired length by
removing the links if needed.
* Please note that depends on chain material thickness,
you might be required to use chain pliers to spread links
open.
b. Pull the supply wires through the Fixture Chain alternating
links. And then pull the wires through the following
components in turn:
Canopy Lock Ring, Ceiling Canopy, Canopy Chain Loop,
Lock Washer, and Nipple.
c. Place Lock Washer over the end of the Nipple and thread
the Canopy Chain Loop onto the end of the Nipple.
d. Using plier, thread the Hex Nut against the Canopy Chain
Loop and tighten until snug.
e. Attach one end of the Fixture Chain onto the Fixture Loop
and attach the another end of the chain onto the Canopy
Chain Loop.
f. Refer to Step 4 - Wire Connections to connect wires.
g. Push the Ceiling Canopy upward over the Outlet Box.
h. Thread the Canopy Lock Ring onto the Canopy Chain Loop
and tighten until snug to secure the Ceiling Canopy.
Nipple
Lock Washer
Canopy Chain Loop
Ceiling
Canopy
Fixture Chain
Canopy Lock Ring
Hex Nut
Fixture Loop
STYLE NUMBER: TF879CVB
2 OF 3