Quoizel KD5015MM Kendra - Manual (Page 4)

STEP 7:
a. Connect the House Ground Wire to the Fixture Ground
Wire.
b. Connect the House White (or Ribbed) Wire to the
Fixture Supply Wire (Black or Smooth Side).
c. Connect the House Black (or Red) Wire to the Fixture
Supply Wire (Black or Smooth Side).
d. Wrap each connection with approved electrical tape
and carefully stuff all of the connected wires into the
Outlet Box.
4 OF 5
WHITE OR RIBBED
BLACK (OR RED) WIRE
GROUND WIRE
WHITE OR RIBBED
BLACK OR SMOOTH
GROUND WIRE
FROM HOUSE
FROM HOUSE
FROM HOUSE
FROM FIXTURE
FROM FIXTURE
FROM FIXTURE
Use Wire Connectors (not supplied) to connect the
wires.
INSTALLATION INSTRUCTIONS
STEP 6:
a. Adjust the Fixture Chain to your desired length by
removing the links if needed.
Please note that depends on chain material
thickness, you might be required to use chain pliers to
spread links open.
b. Pull the supply wires through the Fixture Chain
alternating links. And then pull the wires through the
following components in turn:
Canopy Lock Ring, Ceiling Canopy, Canopy Chain
Loop, Lock Washer, and Nipple.
c. Place Lock Washer over the end of the Nipple and
thread the Canopy Chain Loop onto the end of the
Nipple.
d. Using pliers, thread the Hex Nut against the Canopy
Chain Loop and tighten until snug.
e. Attach one end of the Fixture Chain onto the Fixture
Loop and attach the another end of the chain onto the
Canopy Chain Loop.
f. Refer to STEP 7 - Wire Connections to connect wires.
g. Push the Ceiling Canopy upward over the Outlet Box.
h. Thread the Canopy Lock Ring onto the Canopy Chain
Loop and tighten until snug to secure the Ceiling
Canopy.
STYLE NUMBER: KD5015MM
Nipple
Lock Washer
Canopy Chain Loop
Ceiling
Canopy
Fixture Chain
Canopy Lock Ring
Hex Nut
Fixture Loop