LaMotte DUO-SOFT - Manual (Page 3)

PROCEDURE A - AD DI TION AND RE MOVAL OF RESIN
Allow excess
water to drain
from outlet hose.
4.
Clean
threaded
area
completely
and replace
the black
plug in the
top of
column.
5.
To replace
resin,
remove
black plug
from the top
of dispenser.
1.
By adding more
water to the
3.
column and shaking,
the remaining resin
can be easily removed.
1.
With the aid of a funnel,
add the fresh resin to the
column.
2.
Tap water may
be added to the
resin in the funnel
to facilitate filling of
the column.
Continue adding resin to
the column until the resin is
about 2" from the top of the
column.
2"
3.
Unclamp outlet
hose and turn
softener upside
down.
Allow exhausted
resin and water to
run to waste.
2.
4.
To remove the media in
the bottom chamber,
turn unit upside down
and repeat Removal
Steps 1-3. To add new
media, follow Addition
Steps 1-5 for both
chambers.
A
D
D
IT
IO
N
R
E
M
O
V
A
L
6.
To add the media in the
bottom chamber, turn unit
upside down and repeat
Addition Steps 1-5. When
media has been added to
both chambers, proceed with
Procedure B.
NOTE: When using carbon
it is suggested that the
carbon be used in the top
chamber.