LaMotte DIRECT READING AUTOMATIC BURET ASSEMBLY - Manual

DI RECT READING
AU TO MATIC BURET AS SEM BLY
The Direct Reading Automatic Burets are calibrated to read the test result
directly from the scale on the buret column. The complete assembly,
including a 250 mL or a 500 mL bottle, is designed with flexibility to be
used in any of three modes:
• Self-supported in a reagent tray
• Supported on a buret stand
• Mounted in a kit carrying case
DI REC TIONS FOR AS SEM BLY & USE
1.
The automatic burets are packaged separately to provide protection
during shipment. Carefully unpack each buret and prepare it for use
as described below.
2. Wipe base end (portion that fits
into the reagent bottle) of the
buret clean to avoid
contamination of the titration
solution. Place appropriate screw
cap on base end of buret.
NOTE:
Some automatic burets
are supplied with two different
size caps. Check the titration
reagent bottle to see which cap is
the proper size.
3. Remove the cap from the
titration reagent bottle and insert
the base end of the buret into the
bottle. Securely tighten the screw
cap to the bottle. If necessary, slide the buret down to position the
base end within approximately 1/4 inch of the bottom of the reagent
bottle.
4. The buret assembly may now be mounted in the tray, on the buret
stand or in the carrying case.