CDA HVC 32 - Manual (Page 11)

11
Power Ignition and Adjustment of a Cooking Zone
To turn ON a cooking zone the touch control must be
switched ON (see section “
How To Turn the Touch Control
ON and OFF”).
Press the key and keep it pressed until the desired power
level, ranging between
1
and
9
is set.
As an alternative, press the key . The choice starts from
level
9
(maximum level) down to
1
(minimum level).
To reset the power level press the key and keep it pressed
until power level zero (
0
) or alternatively press the keys
and at the same time.
Functioning of the Double Cooking Zone
The double cooking zone consists of two circuits, which may
be used in the following modes:
– Reduced cooking zone: only the first heating unit is
switched ON.
– Extended cooking zone: the first and second heating
circuits are both switched ON.
Turn on the cooking zone as described in the section: " Power
Ignition and Adjustment of a Cooking Zone"; only the first
heating unit will switch on.
Press the key
to operate also the second heating circuit
(the indicator light close to the key will light up), then set the
desired power level by using the keys
and .
To turn off the second heating circuit press the key (the
indicator light close to the key will go out).
Afterheat in Cooking Zone/s
When switching off a cooking zone (power level
0
), if the
temperature of the zone is too warm to be touched the
display will show alternately "
H
" and "
0
".
Whenever the touch control is switched off, the residual heat
is shown by a static "
H
".
"
H
" is turned OFF when the cooking zone temperature
drops below 65 °C.