Valco Baby Tri-mode Graco - Manual (Page 7)

C
C
Secure the Car Seat
Remove Adaptor
position the car seat so that infant is
facing the handlebar of the stroller.
line up the car seat to the adaptor
frame ensuring that the car seat latch
has clicked on the adaptor frame.
once the car seat is in position, thread
the tether straps through the sides of
the car seat, (where a seat belt would
go) and connect the buckle.
ensure that the strap is tight and
secure by pulling on the free end of the
strap.
to reMoVe the car seat:
detach the straps (reversing the
process used in d) and lift up the car
seat to unlock it from the frame.
to reMoVe the car seat adaptor:
locate the two nylon release buttons
that sit below the frame at each side of
the stroller.
press the release button and lift the
adaptor bar out of the nylon housings.
D
E E
Insert Carseat
6
D