Single/twin car seat adaptor, For use with peg perego – Valco Baby Tri-mode Graco User Manual
Page 4
to secUre twin car seat
adaptor:
replace step c in single
adaptor instructions with the
following two steps c-1 and
c-2:
Located on the Car Ceat Adaptor
support frame are two sets of tether
straps. The first set (as shown in Figure
C-1-
1
)rest on the foot rest of the
stroller.
To secure these straps;
Lift up the footrest flap (Figure C-1-
2
)
and insert the Male clip through the slit
in the stroller frame directly above the
footrest (Figure C-1-
3
).
Wrap the Female clip around the
closest side of the stroller, meeting the
Male clip underneath the footrest of the
stroller.
Insert the Male clip into the Female clip,
and secure.
continue to follow the single
graco car seat adaptor
instructions step d to f.
for Use with
peg perego
single/twin
car seat adaptor:
if you haven’t already done so, remove
the front bar or black plugs from the
nylon housing at either side of the
stroller frame by pressing each inner
“release button” and pulling the front
bar/plug upward.
A
Remove Bumper Bar or Housing
Bumper Bar
Nylon Plug
press
A
1
2
3
Secure the Twin Adaptor
C 1
C 1
C 2
Secure the Twin Adaptor
4
C 2
3