Valco Baby Tri-mode Graco - Manual (Page 5)

B
Insert the Adaptor
Insert the Car Seat
C
B
C
Insert the car seat adaptor connecting
pieces into the nylon housings.
Be sure that the bar release button is
securely in the housing.
position the car seat so the infant is
facing the handlebar of the stroller.
there are three bars on the adaptor
frame corresponding to the three slots
in the bottom of the car seat. line
these up, and push the car seat until it
locks into the frame.
once the car seat is in position, thread
the tether straps through the sides of
the car seat, (where a seat belt would
go) and connect the buckle.
hint : You may have to unsnap the
snaps on the side pockets of the car
seat to locate the slots.
ensure that the strap is tight and
secure by pulling on the free end of the
strap.
D
Secure the Car Seat D
4