Unitec Sierra Site Controller - Manual (Page 9)

W A S H P A Y
Document Number: WP1001 5
3. Mount the NEMA enclosure by bolting it to the wall surface using the included plastic
brackets.
4. Install the Site Controller by fitting the screws on the mounting plate in the NEMA box into
the slots on the rails mounted on the sides of the Site Controller, so that the ports are
installed parallel to the floor. Slide the Site Controller down and tighten the screws to
secure it.
5. Connect the power supply cable and the CAT5 cable. Connect the modem, if applicable.
NOTE: DO NOT install the power supply inside the NEMA box.
Figure 4. NEMA Enclosure with Installed Components
3.3 Router
The router provides network connections for each of the devices to the Site Controller.
Unitec provides and supports a four-port router. If you require additional ports, you will
need to purchase the 16-port Ethernet switch option and use it to expand the network.
The router will fit in the NEMA box, if necessary. When troubleshooting the router, refer
to the documentation received with the router. For information on configuring the
router, see the Unitec Router Configuration Guide.
3.4 Dial-up Credit Modem (Optional)
If you use dial-up credit, you will need to purchase the IPTran credit modem option.
The modem is connected to the Site Controller. The phone line connection is provided
via a RJ-11 jack on the modem. Each modem is pre-programmed with the merchant
Document Name: WashPay Site Controller Installation Manual