Unitec Sierra Site Controller - Manual (Page 11)

W A S H P A Y
Document Number: WP1001 7
Appendix A. Installing the Print Controller
The print controller option allows you to print reports from the WashPay to a printer
connected to the local area network (LAN). The print controller is pre-configured at
Unitec.
Note: You must purchase the USB print cable separately.
Note:
Unitec has tested these printers with the print controller and can verify that they will
work without any additional setup procedures. If you wish to use a different printer,
make sure that it is compatible with the printer driver HP PCL5 or greater.
3 . 4 . 1 . 1 I n s t a l l a t i o n P r o c e d u r e s
1. Connect the USB cable from the printer to the USB port on the print controller.
2. Connect one end of the Ethernet patch cable to the Ethernet port on the print
controller.
3. Connect the other end of the Ethernet patch cable to the router.
4. Connect the AC adapter to the print controller and plug it in.
Document Name: WashPay Site Controller Installation Manual