Tundra HDi3000 - Manual (Page 5)

E_ HD(i)_Guide (E-HD(i)-GD-1113-EN) 5
CAUTION! Leave in the OFF position during the installation.
2.4 Front panel (HD1200 – HD1800 – HD2500 – HDi1800 – HDi3000)
ON/OFF switch: The ON/OFF switch located on the remote control (factory installed on the inverter front
panel) turns the inverter’s control circuit ON and OFF. It does not disconnect power
from the inverter; you must disconnect the AC (120 Volt) and DC (12 Volt) power
before working on any circuits connected to the inverter. When the switch is ON but
no power is being supplied to a load, the inverter draws less than 500 mA. This is a very
low current draw but left in this state the inverter will eventually drain your batteries
until its automatic shutdown at 11 Volt (10 Volt for HDi) (see 4.3). When the switch is
OFF, the inverter draw is Ø (zero).
AC Outlets: The maximum output of your inverter is assumed to go through the two AC outlets.
Never exceed 1800w (or 15A) per outlet. It may result in extensive damages to your
inverter and lead to injuries.
Hard wire outlet:
HD & HDi models are also equipped with one hard wire outlet which can be used as the
only output socket up to the maximum capacity of the inverter.
CAUTION! Leave inverter in the OFF position during the installation.
2.5 Rear panel (all models)
Chassis ground screw: The inverter has a lug on the rear panel to perform a grounding procedure (when
required) to derive AC leaks to ground in case of malfunctioning. Refer to section 3.5
for more details.
Fan(s): In order for the inverter to properly operate, the fan(s) opening must never be obstructed. Allow at least 6
inches (15.2 cm) of clearance around the inverter for airflow. All fans are thermostatic and operate upon the
interior temperature of the inverter.
CAUTION!
Fan(s) will continue to run even if the inverter is on shutdown.