Tundra HDi3000 User Manual
Page 15
E_ HD(i)_Guide (E-HD(i)-GD-1113-EN)
15
Low output voltage
(96 to 105 Volt)
You are using a voltmeter
which cannot properly read
the RMS voltage of a
modified sine wave
Use a TRUE RMS reading
voltmeter
No output voltage
Inverter OFF
No DC power going into the
inverter
Reverse DC polarity
GFCI protection has tripped
Turn the inverter ON
Check the battery cables
Check DC fuse on battery side of
battery cables
Check battery cables for
corrosion or damages.
Refer to the troubleshooting
guide.
Damages caused by reversed
polarity are not covered by the
warranty.
Press the RESET button on the
GFCI receptacle.
You may also refer to the troubleshooting guide: