Tundra HDi3000 - Manual (Page 11)

E_ HD(i)_Guide (E-HD(i)-GD-1113-EN) 11
3.8 DC fuse installation
First, assemble the DC fuse onto the DC fuse holder. Connect the positive cable coming from the cab to one side
of the fuse, and connect the 1 foot cable (30.5cm) to the other side. Do not over tighten the nuts. The terminals
must be solidly fixed onto the fuse holder providing maximum contact. Install the plastic cover.
CAUTION! Not installing the fuse properly can result in fire that may cause severe injuries and/or
damages.
3.9 Battery connections
Cable connection at the batteries - Positive side
The Positive cable is fitted with a red heat shrink. Connect this cable to battery 1 by making sure the terminal is
in full contact with battery link’s terminals. If there is an accessory located on this pole, you must place it on top
of the inverter terminal, NOT underneath.
Cable connection at the batteries - Negative side
The Negative cable is fitted with a black heat shrink. Connect this cable to the most distant possible battery (i.e.:
battery 4) by making sure the terminal is in full contact with battery link’s terminals. If there is an accessory
located on this pole, you must place it on top of the inverter terminal, NOT underneath.
Attach all the cable on the battery links using the cable ties. Do not cut any excess cable. Just make sure it is
properly attached.
CAUTION!
MAKE SURE THE INVERTER IS OFF BEFORE PROCEEDING.
WARNING!
You may observe a spark when making the cable connections since current will flow
for the first time to charge capacitors inside the inverter. This is normal. Always
wear safety glasses and do not make cable connections in the presence of flammable
fumes or material; it may result in explosion and/or fire.
CAUTION!
Reversing the polarity when connecting the DC cables will permanently damage
your inverter. THIS IS NOT COVERED BY THE WARRANTY.