Trebor CP PURUS - Manual (Page 14)

PAGE 14 PURUS CP PUMP OPERATION / MAINTENANCE MANUAL
6.4 PC15 CONTROLLER OPERATION
Ensure that all system interlock and safety devices are functional prior to operation.
Before starting the system, it is important to read and understand the PC15PC manual.
Only trained, qualified, authorized personnel should operate this pump controller.
The controller is operated by using the buttons located on the PLR, see Table 6-1.
Table 6-1: PLC Buttons
Button Normal mode Numeric value change mode
(while digit is flashing)
 Scroll through Menu pages. Activates setup pages when depressed
during Home page.
 Enables/Disables controller
cycling. Activates controller when depressed during
Home page.
 Increases pump cycle rate on
Home page. Increases value of digital readout.
 Decreases pump cycle rate on
Home page. Reduces value of digital readout.
Maintenance alarm page. Displays the Maintenance alarm page
Return to home page Displays the Home page.
6.4.a Turning Pump On and Off
From the Home Page, pressing the RIGHT arrow key (
) will start and stop the
cycling of the pump controller. When activated a cursor will be located below
position 3 (Figure 6-3), accompanied by an oscillating curser between positions 1 &
2 (Figure 6-3).
Figure 6-3: Controller Off Figure 6-4: Controller Cycling
NOTE: See PC15 manual for additional instructions, requirements, limitations and
troubleshooting.