tekmar M3061 Mixing Valve Adapter Kit - Manual

1 of 2 © 2008 D 011A - 11/08
D 011A
11/08
- Data Brochure
Mixing Valve Adapter Kit M3061
The M3061 Mixing Valve Adapter Kit allows mounting of a Belimo GMB24-3
floating point actuator to tekmar cast iron mixing valves. It is compatible with tekmar
valve models 016 through 026. The Belimo actuator is available for purchase through
tekmar (part # M3062) or through an authorized Belimo representative.
Installation
Check the contents of the package. If any of the items listed below are missing or damaged, please refer to the Limited
Warranty and Product Return Procedure on the back of this brochure and contact your wholesaler or local tekmar
representative.
The Mixing Valve Adapter Kit M3061 contains the following components:
Component List
Standoff
(x2)
#8 machine screw
(x2)
Adapter Plate Coupler Shaft
Remove existing actuating motor from
mixing valve. Leave handle in place.
Thread standoff posts into top of valve
and snug tight. Do not over-tighten.
Insert coupler into valve handle, with
both coupler notches pressed into
grooves in handle.
Slide adapter plate over coupler with
torque post facing upwards.
Thread #8 machine screws through
adapter plate holes and into top of
standoff posts. Tighten snug.
Slide Belimo GMB24-3 Actuator first
into torque post (A), then down on
coupler shaft (B). Tighten both of the
shaft clamp nuts. See “Setting the
Belimo Actuator” on next page.
1.
2.
3.
4.
5.
6.
torque post
1 2
3 4
5 6
A B