tekmar 480 User Switch Installation - Manual (Page 4)

© 2009 D 480 - 09/09 4 of 8
Programming the User Buttons
STEP 1:
Remove the plastic trim bezel.
STEP 3:
Press and hold down the User Button until the button changes to the color of operation that is desired and then release
the button.
Red = Scene
Green = tN4 Setpoint Control Enable / Disable
Orange = Disabled Button
STEP 4
(Scene Operation, Red Flashes)
Press the User Button the number of times equal to the desired scene.
Press “User” Button Scene Red Light Flash Sequence
1 Time 1 1 Red, Off, Repeat
2 Times 2 (Away) 2 Red, Off, Repeat
3 Times 3 (Unoccupied) 3 Red, Off, Repeat
4 Times 4 4 Red, Off, Repeat
5 Times 5 5 Red, Off, Repeat
6 Times 6 (3 hr. Temporary Occupied) 6 Red, Off, Repeat
7 Times 7 (4 hr. Temporary) 7 Red, Off, Repeat
8 Times 8 (8 hr. Temporary) 8 Red, Off, Repeat
User
Button
1
User
Button
2
User
Button
3
STEP 2:
Press button “A” once using a blunt object to begin programming mode.
Each of the 3 User Buttons will begin to flash to indicate the current program setting:
• • Red flashes indicate the User Button is programmed to select a scene. The number
of flashes in a row indicate the scene number.
• • Green flashes indicate the User Button is programmed to enable or disable a
tN4 setpoint control. The number of flashes in a row indicate the setpoint device
enable number.
• • Orange indicates the User Button has been disabled.
User
Button
1
User
Button
2
User
Button
3
PRESS
BUTTON
A