Starlight Xpress SXVR-M25C User Manual
Page 3
Handbook for the SXVR-M25C
Issue 1 June 2009
3
Installing the USB system:
First, find a free USB socket on your PC and plug in the USB cable (do not connect
the camera at this time). If you do not have a USB2 capable computer, it is normally
possible to install a USB 2 card into an expansion slot.
The next operation is to run the software installer from the CD ROM provided. Insert
the CD into the computer and wait for Windows Explorer to open with the list of
folders on the ROM. Now find the SXVR-M25C folder and run the SETUP.EXE file
that it contains – this will initiate the self-install software which will guide you
through the process of installing the SX camera software (SXV_M25C_usb.exe) onto
your computer.
Now connect the USB cable to the socket on the camera rear panel.
Windows will report ‘Found new hardware’ and will ask for the location of the
drivers. Point the installer at your CD ROM and the driver installation should proceed
smoothly. (Ignore any warnings about the driver having not been tested by Microsoft).