SoundOff Signal 400 Series Handheld Amp Box - Manual (Page 2)

1.800.338.7337 / www.soundoffsignal.com
Input Settings:
1. Press and Hold Auxiliary Button #1 and #3 until LEVEL #3
LED flashes.
1. Park Kill Polarity Mode: Determines what voltage level will
activate park kill functions. Disables AUX Input
ON = Activated when Ground is applied to Park
Kill input wire.
OFF = Activate when +V is applied to Park Kill
input wire
2. Horn Ring Polarity Mode: Determines what voltage level will
activate Horn Ring functions.
ON = Activated when Ground is applied to Horn
Ring input wire.
OFF = Activated when +V is applied to Horn
Ring input wire.
3. PA Volume Control (see Setting PA Volume)
ON = RR Button Adjustable
OFF = Programmed
4. Level 3 Tone Activation : Determines when the siren tone
push-buttons on control panel are enabled.
ON = Tone push buttons always enabled
OFF = Tone push button only enabled with slide
switch is in position #3.
5. 8 Second Buzzer alert: Provides audible beep when
ever any auxiliary switches are ON or level 1, 2 or 3
is active.
ON = Enabled
OFF = Disabled
Slide Switch Mode:
1. Press and Hold Auxiliary Button #1 and #4 until Level 2 LED
flashes.
2. Press Auxiliary switch 1, 2, or 3 depending on required mode of
operation.
Aux 1: Progressive 1,2,3
Level 1 selected: Active Outputs: 1
Level 2 selected: Active Outputs: 1,2
Level 3 selected: Active Outputs: 1,2,3
Aux: 2 Progressive 1,2,3 with option to turn off lower levels
Level 1 selected: Active Outputs: 1
Level 2 selected: Active Outputs: 1,2 (Level 1 may be turned OFF)
Level 3 selected: Active Outputs: 1,2,3 (Level 1 and 2 may be
turned OFF)
Aux 3: Individual 1,2,3
Level 1 selected: Active Outputs: 1
Level 2 selected: Active Outputs: 2
Level 3 selected: Active Outputs: 3
Toggle ON/OFF
Momentary ON
8 Second Delay
Left Arrow
Right Arrow
Center Out - Arrow
Alley Left
Alley Right
Single Button Arrow
Single Button Alley
4. Press and release Auxiliary Button until desired mode is
selected.
5. Continue steps 2-4 for any other Auxiliary Buttons needing to
be programmed.
LEGEND:
ON =
Denotes Factory Default Setting
HANDHELD REMOTE
PSRNHHC1
6
PROGRAMMING MANUAL
NOTE:
For All programming modes: Momentarily depress Radio
Rebroadcast push-button to save and exit.
To hear samples of all the tones available go to
www.sousoundoffsignal.com website.
Programming Modes
Auxiliary Button Programming:
1. Press and Hold Auxiliary Button #1 and #6 until Level 1 LED Flashes.
2. Press the auxiliary button which setting is going to be viewed/
changed.
3. Monitor the Arrow/Alley LED’s to determine setting for Auxiliary
Button
ETSA46(x)HPP 3.4.13
6 . Air Horn Button Output Channels
ON = In standby mode, Air Horn tone is output
on Spkr A & B. When Warning Tone is
Active, Warning Tone continues on Spkr A &
Air Horn Button Tone is output on Spkr B
OFF = Air Horn Button Tone always
produced on Spkr A & B.