SoundOff Signal 600 Series 6 Function Switch - Manual

To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product please visit our website at www.soundoffsignal.com and select the “Warranty & Returns”
link along the left column of our home page. If you have questions regarding this product please contact Technical Services, Monday - Friday, 8 am to 5 pm at 1.800.338.7337, press #4 to
skip the automated message. Questions or comments that do not require immediate attention may be emailed to [email protected].
1.800.338.7337. / www.soundoffsignal.com / Thank you for trusting us with your safety!
OPERATION:
Switches are sequential from left to right on
front panel. Note that switch 1 is 40A (inter-
nal) and switches 2-6 are 20A fused.
SAFETY NOTICE:
The outputs of the switch panel are protect-
ed with a 40 Amp thermal breaker on main
input and individual fuses on the outputs.
Make sure to only replace with same type
and rating of fuse.
Make sure to properly fuse the supply wire
at the source of power in the event of a
short circuit. Also make sure the wire gauge
is sufficient to carry a minimum of 50 Amps
of current.
600 SERIES SWITCH PANEL
INSTALLATION INSTRUCTIONS
ETSP6F
• DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to your vehicle
Owner’s Manual for the location of any air bag deployment zones.
ETSP6F 2.14
Important Information:
INSTALLATION:
Immediately after unpacking, examine the
switch panel for any damage that may have
occurred during transit. If the equipment
has been damaged during transit, promptly
file a claim with the carrier. Carefully check
all envelopes, shipping labels, and tags
before removing or destroying them.
MOUNTING YOUR SWITCH PANEL:
This switching system comes with a
Universal Bail Bracket that allows for
versatile mounting in position needed.
Positioning the bracket below the unit
permits it to be mounted on a horizontal
surface. Positioning the bracket above
the unit permits it to be mounted to the
underside of the dash.
Determine where you will locate the unit
then use the mounting bracket as a guide
and drill holes into the mounting surface
using the appropriate size drill bit.
The bracket can then be mounted to the
surface. The type of hardware will vary
depending on what surface the switch panel
is being mounted to.
SAFETY NOTICE:
When drilling into the vehicle, ensure
that both sides of the surface are clear of
anything that could be damaged.
DIMENSIONS
Overall
Dimensions:
6.2”L x 5.2”W x
2.2”D
REPLACEABLE LEGENDS
SW 1 (INTERNAL 40A)
SW 2-6 (20A)
1 2 3 4 5 6
FUNCTION WIRE COLOR LABEL GAUGE
Switch 1 Red 12
Switch 2 Blue 14
Switch 3 Gray 14
Switch 4 Yellow 14
Switch 5 Orange 14
Switch 6 Green 14
Main Power Red “H” 8
Ground Black “G” 18
Backlight Red “B” 18