SoundOff Signal 400 Series Console Amp Box - Manual (Page 3)

2 . Buzzer: Audible tone from control panel whenever operator
presses push-button or changes position of slide/rotary
switch
ON = Buzzer enabled
OFF = Buzzer disabled
4 Hands Free Mode: (Alternate Horn Ring Control Must be
Disabled) Activates the siren tone when operator
momentarily presses on Vehicle Horn.
ON = Enabled
OFF = Disabled
5 . Power Down: Determines siren operation after ignition wire
input has no voltage
ON = Timed Power Down: Siren will
power down 10 min. after last Aux
Button activity.
OFF = Immediate Power Down: Siren
will go into lowest power state within 10
seconds.
SLIDE SWITCH SETTINGS:
1. Press and hold Auxiliary Push-Button “1” and “4” until slide
switch #2 indicator LED flashes.
2. Press Auxiliary Push-Button “1”, “2” or “3” depending on
which configuration for the slide switch is required.
6 . Horn Ring Standby Tone: (Hands Free Mode must be
disabled for this function to work)
(Alternate Horn Ring Control Must be Disabled)
Determines which tone to output when siren is in standby
and vehicle horn is pressed
ON = Air Horn
OFF = Wail Tone
7. 8 Second Buzzer alert: Provides audible beep whenever any
auxiliary switches are ON or level 1,2, or 3 is active.
ON = Enabled
OFF = Disabled
HIGH
LOW 2
6 5
3
7
4
Setting PA Volume:
1. Press and Hold Auxiliary Push-Button “1” and “2” until slide switch
#2 and #3 indicator LED flashes.
2. Depress and hold PA switch on microphone and press Push-button
“1”-“8” depending on volume required. When correct
volume is determined, press Radio Rebroadcast and the
volume setting will be permanently stored.
ALTERNATE MODES:
1. Press and Hold Auxiliary Push-Button “2” and “6” until Slide
Switch indicator #1 and indicator #2 LED flashes.
1 . Alternate Horn Ring control: Custom operation of vehicle
horn when pressed. Refer to figure below for details.
ON = Enabled
OFF = Disabled
2 . Alternate Horn Ring control option: (Alternate Horn Ring
Control must be enabled). Custom operation of vehicle
horn when pressed. Refer to figure below for details.
ON = Option 2
OFF = Option 1
ALTERNATE HORN RING CONTROL
OPTION 1 OPTION 2
STANDBY OEM HORN OEM HORN
LEVEL 1 OEM HORN OEM HORN
LEVEL 2 Air Horn or Wail
Button Tone while
Pressed *
Tap to Turn On Warning Tone,
Tap again to Change Warning
Tone. Press and Hold for Air
Horn Tone
LEVEL 3 Tap to turn ON
Warning Tone, Tap
again to change
Warning Tone. Press
and Hold for Air Horn
Tone
TONE
SWITCH OFF:
Air Horn Tone
or Wail Button
Tone while
Pressed *
TONE
SWITCH ON:
Tap to change
Warning Tone,
Press and Hold
for Air Horn
Tone
BACKLIGHT INTENSITY:
While pressing RADIO REBROADCAST BUTTON,
press Auxiliary Push-Button “1”-”8” to adjust backligh intensity.
“1” = Lowest intensity, “8” = Highest intensity.
Backlight must be enabled by the Gray wire on CN6.
OTHER MODES:
1. Press and Hold Auxiliary Button “1” and “5” until slide switch
#1 and #3 indicator LED flashes.
1. Horn Ring Activation: Determines when pressing the
Vehicle Horn will activate siren tone
ON = Enabled only when slide switch is
in level position 3
OFF = Enabled whenever siren is ON
3 . Speakers diag LED disable: Disabling S2 LED does not
turn off secondary speaker channel
ON enable S2 LED (200W system)
OFF disable S2 LED (100W system)
3. GUN LOCK SECURITY:
ON = Operator must press Standby button
within 1 second after pressing 8
second time delay button to active
switch
OFF = 8 second time delay switch is
activated immediately when
pressed
7
SLIDE SWITCH SETTINGS
MODE RELA
Y
OUTPUT
#1
RELA
Y
OUTPUT
#2
RELA
Y
OUTPUT
#3
SLIDE SWIT
CH
POSITION
1
AUXILIARY PUSH-BUTTON 1
IS SELECTED
 1
  2
   3
2
AUXILIARY PUSH-BUTTON 2
IS SELECTED
 1
 2
 3
3
AUXILIARY PUSH-BUTTON 3
IS SELECTED
 1
 2
   3
ETSA48(x)CSX 3.4.13
8 . Air Horn Button Output Channels
ON = In standby mode, Air Horn tone is output
on Spkr A & B. When Warning Tone is Active,
Warning Tone continues on Spkr A & Air Horn
Button Tone is output on Spkr B
CONTROL PANEL
PSRN4CTRL2
PSRN4CTRL3
PROGRAMMING MANUAL
* Set in “Other Modes” 6. Horn Ring Standby Tone
OFF = Air Horn Button Tone always produced on
Spkr A & B.