SoundOff Signal 400 Series Console Amp Box - Manual (Page 2)

CONTROL PANEL
PSRN4CTRL2
PSRN4CTRL3
PROGRAMMING MANUAL
NOTE:
A. For All programming modes: Momentarily depress Radio
Rebroadcast push-button to exit.
B. To hear samples of all the tones available go to www.
soundoffsignal.com website.
INPUT SETTINGS:
1. Press and Hold Auxiliary Button 1 and 3 until slide switch #3 LED
flashes.
1. Park Kill Polarity Mode: Determines what voltage level will
activate park kill functions.
ON = activated when +V is applied to Park
Kill input wire.
OFF = activated when Ground is applied to
Park Kill input wire.
5. Horn Ring Timeout: (Alternate Horn Ring control must be
disabled and hands free mode must be enabled for
function to have any effect). When vehicle horn is
pressed and tone changes, determines how tone will
change back to pre-vehicle horn press tone.
ON = siren tone will revert back to
pre-vehicle horn press tone after 8
seconds
OFF = siren tone will not revert back
to pre-vehicle horn press tone
6. Park Kill Latch: When Park Kill input is triggered, determines
how siren tone proceeds once park kill input is no longer
active. (Disables Auxiliary Input)
ON = Tone remains disabled until
operator selects other tone
OFF = Tone resumes once Park Kill input
is no longer active
7. Horn Ring Scroll: (Hands Free Mode must be enabled for
function to have any effect) Determines how siren tone
will change each time the operator presses the vehicle
horn.
ON = Tone will advance through tones
programmed on Wail, Yelp, and Tone
push-buttons each time vehicle horn is
pressed
OFF = Tone will switch between tones
programmed on Wail and Yelp push-
buttons each time vehicle horn is pressed
8. Auxiliary Input: Determines which siren tone will be activated
when auxiliary input is activated.
ON = Air Horn tone
OFF = Tone which is programmed on
Wail push-button
LEGEND:
ON - GREEN
OFF - BACKLIGHT ON - RED
BACKLIGHT OFF - OFF
GRAYED AREAS DENOTE FACTORY DEFAULTS
Slide Switch LEDs
Arrow Control display
AUXILLARY BUTTON #s
1 2 3 4
5 6 7 8
6
DON’T CARE
2. Horn Ring Polarity Mode: Determines what voltage level will
activate Horn Ring functions.
ON = activated when +V is
applied to Horn Ring input wire
OFF = activated when Ground is
applied to Horn Ring input wire
3. Tone Select*: Determines if the Tone Select activation will
allow a siren tone to be produced.
ON = Tone Push-button Enabled
OFF = Tone Push-button Disabled
4. Level 3 tone activation*: Determines when the siren tone
push-buttons on control panel are enabled.
ON = Tone push-buttons always
enabled
OFF = Tone push-buttons only
enabled when slide switch is in
position #3.
1.800.338.7337 / www.soundoffsignal.com
ETSA48(x)CSX 3.4.13
Slide (Level) Switch
(Siren & Multiple Outlets)
S1 Primary Speaker
S2 Secondary Speaker
Diagnostic
Siren Control Select *
(Single Output)
C. The Push Button version (shown above) works the same as
the rotary switch version with 2 exceptions:
1. Gun Release Interlock (Button:STBY; Rotary: RR)
2: Rotary Switch version only - Parasidic Current- To place
unit in lowest possible current consumption mode (with
ignition off), rotary switch must be in “off” position.
* Siren Control Select for push button or rotary switch
versions program the same.
Siren Control
Momentary
PUSH BUTTON (SHOWN BELOW) SIMILAR TO ROTARY SWITCH (NOT SHOWN)