SONIQ QV290 - Manual (Page 9)

７
1 Select a desired program
●Use the direct Program No. selection buttons
Operation method see previous page "buttons on remote controller."
●Use the Program No. Up/Down Button “P+” “P-” buttons
Pressing “P+” will select a Program No. in the increasing number;
Pressing “P-” will select a Program No. in the decreasing number.
2 Adjust the volume by Volume “V+/V-” button.
3 If the color of a channel is not normal, it may be a wrong setting of color system, and
it can be adjusted as described below:
Directly pressing the SYSTEM button on the remote controller to select the correct
color system.
AUTO→PAL→PAL/M→PAL/N →N3.58 →N4.43 will appear in turn.
Note: If you are using the machine for the first time, please first make the automatic
searching and store the programs as described in “Adjustment” in the subsequent
page.
When you turn on the TV set for the first time, please operate as follows.
1 Program presetting (automatic searching)
Press the “MENU” button continuously on the machine to enter "PRESET", so that the
following menu is displayed on the screen:
Use “P+/P-” button to select “AUTO-SEARCH” option, now the characters of this
option turn red, then press “V+/V-” button to place the machine in the automatic searching
Start operation: Watch TV programs
TV Operation
Start operation: Adjustment
PRESET
POSITION 2
MEMORY NO
FINE
SEARCH
AUTO —SEARCH
l l l l l l l l l l l l . . . . . . . . . .60
CH+/CH- :SELECT
VOL+/VOL- :ADJUST