SONIQ QPB302B - Manual (Page 20)

-20-
{ 16:9 Normal} – For a disc with the
aspect ration of 4:, the output video is
resized vertically to match what will be
seen on the display.
{ 4:3 Pan&Scan} – For standard TV,
Display a wide picture on the entire
screen and cuts off the redundant
portions.
{ 4:3 Letterbox} – For standard TV,
Display a wide picture with two black
borders on the top and bottom of 4:
screen.
• [Resolution]
Select a video output resolution that is
compatible with your TV display
capability.
{ Auto} – Select the most suitable
resolution according to the input video.
{ 480I/576I},{480P/
576P},{720P},{1080I},{1080P} – Select
a video resolution setting that is best
supported by the TV, See TV manual for
details.
• [TV System]
If the video does not appear correctly,
change the setting.By default, this
setting matches the most common
setting for TVs in your country
{ NTSC} – For NTSC-system TV.
{ PAL} – For PAL-system TV.
{ Multi} – For Multi-system
TV,compatible with both PAL and
NTSC.
• [Color Space]
Select a predenfined color space of
picture
{ RGB} – Select RGB color space.
{ YCbCr} – Select YCbCr color space.
{ YCbCr422} – Select YCbCr422 color
space
{ Full RGB} – Select Full RGB color
space.
• [HDMI Deep Color]
This feature is available only when the
display device is connected by a HDMI
cable, and when it supports deep color
feature.
{ Off} – Output standard 24 bit color.
{ 30 bits} – Output 0 bits color.
{ 36 bits} – Output 6 bits color.
• [HDMI 1080P 24Hz]
{ On} – Enable to select this video
resolution setting.
{ Off} – Disable to select this video
resolution setting.
[Video Process]
• [Video Adjust]
Select a predefined set of the video.
1. Press OK .
2. Press to adjust the video
Brightness, Contrast, Hue and
Saturation.
. Move to [ Exit] to exit.
Brightness
Contrast
Hue
Satutation
Return Exit Change
• [Sharpness]
Select the sharpness level: High,
Middle, Low.
Audio Setting
1. Press . Press Press SETUP
[General Setting] menu is displayed.
2. Press . Press Press  to select [Audio Setting],
then press  .
. Select an option, press . Select an option, press Select an option, press  to access.
Home Exit
Audio Output Spdif PCM
PCM
48K
Use cursor key to move focus,use
“Enter ” key ro select
HDMI
Down_samp
Off DRC
... Audio Setting...
4. Press . Press Press  to select a setup option and to select a setup option and
press 
5 . Select the setting you wish to change
and press OK to confirm.
- Press  to return to the previous
menu.
- Press SETUP to exit the menu.
[Audio Output]
• [Spdif]
Select the output mode of Digital Out
jack, options include Bitstream, PCM,
Reencode and Off.
Customizing