SONIQ QMS300B - Manual (Page 3)

z Do not attempt to clean this unit with
chemical solvents as this might
damage the finish. Use a clean dry
cloth.
z Avoid installing this unit in places
exposed to direct sunlight or close to
heat radiating appliances such as
electric heaters, on top of other stereo
equipment that radiates too much heat,
places lacking ventilation or dusty
areas, places subject to constant
vibration and/or humid or moist areas.
z Operate controls and switches as
described in the manual.
z Before turning ‘On’ the power, make
certain that power cord is properly
installed.
z No naked flame sources, such as
lighted candles, should be placed on
the apparatus.
z When moving the set, be sure to first
disconnect the power cord.
z The apparatus shall not expose to
dripping or splashing. No objects filled
with liquids, such as vases, shall be
placed on the apparatus.
UNPACKING AND SET UP
z Carefully remove all the components from the display carton and verify that
you have all the necessary components before you dispose of the display
carton.
z Remove all packing materials from the individual components. Remove any
descriptive labels that may be attached to the front panel of the main unit. Do
not remove any labels or stickers on the back panels of the main unit or the
speakers.
z Place all the components in the desired location. This system is designed to
be used on level, stable, flat surface such as a table, desk, shelf, or stand,
convenient to an AC outlet, out of direct sunlight, and away from sources of
excess heat, dust, moisture, or vibration.
z Unwind the AC power cord on the back of the unit and extend the cord to its
full length
.
- 2 -