Chamberlain 5100-2K - Manual (Page 33)

Receiver and Remote Control Programming
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death. Do not allow children
to operate the door control(s) or remote
control transmitter(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
Your garage door opener receiver and remote
control transmitter(s) have been set at the factory to
a matching code. The opener will activate when the
LARGE button on the remote(s) is pressed. The
multi-function remote(s) can also activate additional
garage door openers and/or light control models
874CB and 872CB.
Your "Smart" garage door opener will operate with:
• up to twelve "Smart" remote control transmitters
(with green indicator lights),
• a Keyless Entry System and
• code switch remote controls with red indicator
lights.
Below are instructions for programming your opener
to match the other buttons on your multi-function
remote and any additional remotes you may
purchase. See available accessories on page 38.
To Add A Remote
Select a push button to operate the receiver, Figure 1.
1. Press and hold the remote push button.
2. Then press and release the "Smart" button on the
back panel of the opener (Figure 2). The opener
lights will
flash once.
3. Release the remote push button.
Now the opener will operate when the remote
control push button is pressed.
If you release the remote control push button
before the opener lights flash, the opener will
will not accept ththe code.
To Change the Selected
Push Button On the Same Remote
If you decide to use a different remote control button
than originally programmed into the opener, you
need to erase
all the learned codes and reprogram
each remote used to operate the garage door
opener.
To Erase All Remote Control Codes
• Press and hold the "Smart" button on the opener
panel until the indicator light turns off (about 6
seconds).
All the codes the opener has learned
will be erased.
• To reprogram, repeat Steps 1 – 3 for each remote
control in use.
Code programming instructions are also located
on the opener panel.
33
Multi-Function Remote Control
Select a Remote
Push Button
Battery
Indicator Light
Garage Door Opener
(With "Smart" Button)
END PANEL
"Smart"
Button
Indicator
Light
KG KG
1
3
9
7
5
1
3
9
7
5
1 2 3
Figure 1
Figure 2
WARNING
NOTICE: To comply with FCC rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the
code setting or replacing the battery. THERE ARE NO OTHER USER
SERVICEABLE PARTS.