Compuprint SP40 User Manual
Page 35
31
S
S
e
e
t
t
u
u
p
p
P
P
a
a
r
r
a
a
m
m
e
e
t
t
e
e
r
r
s
s
The following is a listing of the setup parameters.
Configuration Sheet
Setup Parameter
Values
Description
RESTORE TO MFG
no
all
config
prog. 1,
prog. 2
The selected values are not set to factory defaults.
The values set in all printer setups are reset to factory default
values.
The values set in the configuration setup are reset to factory default
values.
The values set in the corresponding program setup are reset to the
factory default values.
PROGRAM progr.
1,
progr. 2,
on interface
Defines the default Program Setup. Selecting
progr.1
or
progr.2
the setup parameters set in the corresponding Program
Setup are set.
Selecting
on interface
the printer matches the Program 1
settings w ith the data arriving on the Centronics interface, and the
Program 2 settings w ith the data it receives from the serial interface.
When changing from one interface to the other, the default values
are set for the corresponding Program Setup.
ERROR BUZZER
enable, disable
Enables or disables the buzzer in case of an error.
JOB BUZZER
no beep,
Selects the behavior of the buzzer w hen a new print job starts: no