Warning – SONIQ AWM2301 User Manual

Page 3

W-A

W-C

√

WARNING

• Make sure that mounting screws are anchored into the center of the studs. Use of a stud finder

is highly recommended.

• Installers are responsible to provide hardware for other types of mounting situations.

• Installer must verify that the supporting surface will safely support the combined load of the

equipment and all attached hardware and components.

2a. Wood Stud Wall Mounting:

• When installing wall mounts on cinder block, verify the actual concrete thickness is at least
1-3/8" (35mm) for using the concrete anchors. Do not drill into mortar joints! Be sure to
mount in a solid part of the block, generally 1" (25mm) minimum from the side of the block.
It is suggested electric drill on slow setting is used to drill the hole instead of a hammer drill
to avoid breaking out the back of the hole when entering a void or cavity.

• Installer must verify that the supporting surface will safely support the combined load of the
equipment and all attached hardware and components.

WARNING

2b. Solid Brick and Concrete Block Mounting:

55mm/2.2"

ø 4.5mm
ø 3/16"

60mm/2.4"

ø 10mm
ø 3/8"

Drill pilot holes

Screw the wall
mount onto
the wall

√

with the up arrow of the plate upward

1. Removing the Decorative Covers

W-B

W-C

W-A

-3-

-4-