Cal Flame 3000 - Manual (Page 44)

TROUBLESHOOTING PROCEDURES
If Grill Fails to Operate Properly:
1. Turn off gas at source, turn the Control Knobs to the ‘OFF’ position and wait 5 minutes before trying again.
2. Check gas supply at a connections.
3. Repeat lighting procedure and if grill still fails to operate properly, turn off gas at source, turn the control
knobs to the off position and wait for the grill to cool down and check the following:
Problem: Misalignment of burner tube(s) over orifice(s)
Solution: Reposition the burner tube to properly seat over orifice.
Troubleshooting Procedures Owner’s Manual
Figure 41. Burner Tube Reposition
Problem: Obstruction In Gas Line
Solution: Remove fuel line from grill. Do not smoke or perform any maintenance in the vicinity of an open
flame. Open gas valve for one second to blow out any debris. Close off gas valve and reconnect
fuel line securely.
Problem: Plugged Orifice
Solution: Remove cooking grills, Flame Tamer and grease tray. Remove burners from bottom of firebox
by pulling cotter pin from beneath burner peg using a standard screwdriver or needle nose
pliers. Carefully lift each burner up and away from the gas orifice. Remove the orifice from the
control valve. Gently clear any obstruction with a fine wire. Reinstall orifice, reinstall burners
over orifices and seat burner peg into position hole at the bottom ledge of the firebox. Replace
cotter pins. Replace cooking components and grease collectors. If an obstruction is suspected in
the control valve, please contact your local Cal Flame dealer for assistance.
Page 43 Owner’s Manual