beautypg.com

Rite-Ride 4174 User Manual

Warning

background image

R

ECOMMENDED

O

PERATING

P

RESSURES

Van

5 - 35 p.s.i.

23-8373

10-10

NAD-29686-1

DESCRIPTION

QTY.

AIR SPRING

2

PLUG

1

LOWER PROTECTOR

2

UPPER PROTECTOR

2

18' AIR LINE

1

NYLON TIE

6

INFLATION VALVE

2

5/16" FLAT WASHER

4

PARTS LIST

Read installation instructions in its entirety before installing your Coil-Rite Kit

4174

S

TEP

1 - V

EHICLE

PREPARATION

Remove the positive battery cable. With the vehicle on

a solid level surface chock the front wheels. Raise the rear
wheels of the vehicle using a lift or platform jack rated for
your vehicle weight. Lower the vehicle frame onto jack
stands rated for your vehicle's weight making sure the
suspension is fully extended. (DO NOT use wood or
concrete blocks to support the weight of the vehicle.)

S

TEP

2 - A

IR

SPRING

PREPARATION

Cut a section of air line tubing 3 inches in length and

insert into the push-to-connect air inlet on the air spring
(a "saw" cut with a sharp knife is preferred). Exhaust the
air from the air spring by rolling it up toward the air inlet.
After the air is exhausted, install the plug into the tubing
coming out of the air spring see Figure "A".

S

TEP

3 - I

NSTALL

PROTECTOR

Place the lower protector in the bottom of the coil

spring. Install the upper protector onto the stud inside the
coil spring. See Figures "B", "C", & "D".

S

TEP

4 - I

NSTALL

THE

AIR

SPRING

Insert the bottom of the flattened air spring into the coil

spring through the lowest opening in the coil spring with
the push-to-connect air inlet at the bottom of the coil
spring see Figure "D".

WARNING

Do not inflate this assembly when it is

unrestricted. The assembly must be restricted by
a coil spring. Do not inflate beyond recommended
operating pressures for your specific vehicle.
Improper use or over inflation may cause property
damage or severe personal injury.

FOR BEST RIDE use only enough air

pressure in the air helper springs to level the
vehicle when viewed from the side (front to
rear). This amount will vary depending on the
load, location of load, condition of existing
suspension and personal preference.

FIGURE "A"

FIGURE "B"

PLUG

AIR LINE

COIL-RITE

AIR SPRING

COIL SPRING

LOWER PROTECTOR

www.riderite.com